The black curl 3.0 commercial

[elty001]

 

[elty001]

 

[elty001]

 

[elty001]

 

[elty001]

Still plenty more to go at

 

[elty001]

Hopefully get some more done this coming weekend if the weather holds out.

 

[Flying Torquewrench]

Certainly keeps you busy! What do you use to cut the old metal out? I always find it difficult to get into the nooks and crannies.

 

[elty001]

Certainly keeps you busy! What do you use to cut the old metal out? I always find it difficult to get into the nooks and crannies.

I mainly use the angle grinder.
Have also got a reciprocating saw with a metal blade and a good selection of sharp chisels.

 

[Banshee]

Good work Elts :thumb2

I didn't think it was as bad as that but hopefully that'll be the last of it :bow

I've got enough on at the moment but believe it or not I still miss that truck!!!

I think because, it's SWB, Black, 3.0 & Commercial it just ticks all the boxes

Keep at it mate, I can't wait for a drive of it on the lanes

 

[elty001]

Good work Elts :thumb2

I didn't think it was as bad as that but hopefully that'll be the last of it :bow

I've got enough on at the moment but believe it or not I still miss that truck!!!

I think because, it's SWB, Black, 3.0 & Commercial it just ticks all the boxes

Keep at it mate, I can't wait for a drive of it on the lanes

I'm hoping the bad rot is confined to the rear end but i'll be honest and say i don't hold much hope out for the rest of it
Until i get properly underneath with the hammer and chisel and give the chassis a good going over i won't know for sure.

 

[Flying Torquewrench]

I mainly use the angle grinder.
Have also got a reciprocating saw with a metal blade and a good selection of sharp chisels.

Cheers! :thumb2 May have to invest in some more tools.

 

[elty001]

Been plodding on bit by bit when i have chance with this project.
Interior has been totally stripped out and i made a start on sorting out the rotted sections.

 

[elty001]

Built myself a little carport to work under also.

 

[terranosaurusdoug]

Nice mate :thumbs

 

[elty001]

Got a bit more done this afternoon.

Wheel arch all welded up,seam sealed and a coat of trimite black single pack etch primer brushed on the new metal.

 

[elty001]

 

[Flying Torquewrench]

Looking good! :thumb2 More rust then you expected?

 

[solarman216]

Yes Elt looking good, shame these motors rust in the most awkward places, Rick

 

[Banshee]

He knows what he's doing :bow

 

[elty001]

Looking good! :thumb2 More rust then you expected?

I've learnt not to underestimate how much these things rot:lol