Properly cold day in the unit
At one point it got to a balmy zero degrees. I was double gloved :lol
The kettle was busy and helped me get all those fiddly external ancillary bits on the block before I forgot where they went. Never done so much part cleaning. I'm asking the Easter bunny to bring me a parts washer :thumbs
Oil filter housing seals
It scrubbed up well enough to spot any leaks at least :lol
Turbo water pipe also cleaned and fitted
On the other side it's a lot easier just had to fit sender and oil pipe to vacuum pump ( I think lol )
At last onto the shiny shells , after more cleaning
Mr Crank has entered the building :naughty
Mains oiled , thrusts in and all tightened up :clap
Finally today as my fingers were frozen stumps I just managed to get the crank oil seal plate on.
Tomorrow night it's piston time :beer