Elty001's terrano project

Nissan 4x4 Owners Club Forum

Help Support Nissan 4x4 Owners Club Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Wish I could still weld like that but hands just not responding like they used to as well as the eyes not up to it, keep up the good work, keep her going Rick:thumb2:thumb2
 
Sometimes I wish I couldn't weld :lol:lol
Got a cross member and a couple of holes in the footwell to do on this for the next door neighbour's son.
At least this will put some money in my pocket though:thumbs
IMG-20200912-WA0006.jpg
 
Finally got my arse in gear and got some paint on the chassis.
IMG-20201018-WA0009.jpg
 
IMG-20201018-WA0007.jpg
Not done much else on it other than swap a seized front brake caliper.
 
Looks good Elty. At least that should keep it together for a few more years. :thumbs

Fingers crossed :thumb2
Found another crusty bit of bodywork just under the abs pump on the inner wing that's going to need some attention in the near future but that's a relatively simple fix.
 
Bit of routine maintenance today.
New ball joints,tie rods and swap a split boot on the drive shaft.
IMG-20201127-WA0001.jpg
 
All back together now ready for a tracking check in the morning :thumb2
IMG-20201127-WA0025.jpg
 
That bumper is looking good. :thumbs

Cheers Wallace :thumb2
My rear is in need of a bit of TLC so tempted to start from scratch and fabricate one to match the front but that project is a long way off yet.
 

Latest posts

Back
Top