Search results

The interior light doesn't come on when you open the door on my terrano. The boot one and the middle one come on and go off on opening and closing doors but the front one doesnt. The lights work if you switch them on so the bulbs are ok. Is this a problem with the unit or a wiring problem...

The rear door handles on my terrano are getting really hard to open. Its getting to the point where I just open them from the inside instead of battling trying to squeeze the handle open. Is there a way to make them easier to pop open? Is it a cable that needs adjusting or is it new...

When I put the new battery in it was running at 13.4v. Now sat its 12.1v and running at 13v

I'll try a new alternator I think. Thanks for the advice

I posted a thread just before christmas regarding my teranno not charging properly. I did as was advised and checked earths and I checked the ignition wiring. I found that I had a loose wire in the ignition. Don't know if this was the cause as the battery was still dead. It would only start...

It turns out it was a loose wire in the ignition switch, thanks for the advice on checking the cabling. Its now fired up on jumping, I ran it for 30 minutes to charge the alternator up and then left it for half an hour and it fired up straight away. I then drove for less than a mile to the...

and yesterday was the last time it started ok

I have yeh, left it for a while after it had gone out. The coil is taking longer to go out than usual tho.

Interior lights dim when cranking over, but its too dark now to check the voltage

Do you mean while turning the key? Its that dead it doesn't have enough power to turn over slightly. Yet all the lights work ok and the stereos fine.

Haha its a mistral, I didn't even realise I put T2 on my sig, I'll change it not to confuse anymore. I've checked the cabling and everything seems fine. I've just had a look at the battery and its a Yuassa 12v 95AH 700CCA, I was told this would be more than enough to power it. Is that right...

Well I finally plucked up the courage to go outside in the cold and check the atf level. And guess what, the flaming car won't start now. I've just bought a new battery 2 months ago and its been running fine. I've tried jumping it off a battery pack and our other car but no joy at all, its...

thanks for that, I'll have to go out and freeze my arse off and check the level. Is there a certain brand of oil to use?

Hopefully someone can help. My terranos gears are slipping slightly. But only after the car has either warmed up or after a longish journey. I'll be steadily driving along and then it will rev high and start to slow down, and if I come to a stop or set off from standing it will judder. Is it...

Hi Karl Just drop us a line when you know what you're after. I'm sure we can help you out. Cheers Mark

I'm sure we can sort sumert out

Signs & Graphics I'm a signmaker in Huddersfield. We produce shop signs, banners, vehicle graphics, leaflets, business cards, printed clothing and canvas pictures. So if there's anything we can do for you give us a call or drop us an email. We do most of our work with local trades but we...

Your best bets to put it on dry, the top application tape can be a sod to get off if you've soaked the vinyl too much. You need to dry it off with a heat gun or hair drier to make the glue dry. Just use a pin to get rid of air bubbles, if you use enough pressure when applying you shouldn't...

Think I've found what I needed but 1 little problem. With in the alarm system there are wires to connect to the ignition wires. It states: Connect blue wire to ACC Connect brown wire to ignition 1 Connect brown wire to ignition 2 Connect yellow wire to starter But on the ignition barrel there...

I've looked through that, I've found plenty of diagrams for it but I just can't make head nor tail of it. I'm trying to find "ACC" "STR" (which is starter and I've found that, "IG1" and "IG2" which is ignition 1 and 2, These are in the alarm installions but on the ignition it says ACC, 1, 2 and...