Search results

Thanks Rick that would be great.

Hi Rick, I'm in Farnham, Surrey so approx. 90 miles from you. Lee

Hi my mate repaired both my rear sills but forgot to mention the sunroof drain pipe runs down into them probably why they always rot out. Should I drill a hole in the back so they can drain out?

Maverick wings Forgive me I'm in the same boat needing a near side wing for my 98 Maverick. Are they the same as the R20 wings? As found this on e-bay and they have the same rounded front shape to the wing...

Have you seen this on E-bay. looks like a good price. https://www.ebay.co.uk/itm/Fender-Wing-Set-RIGHT-AND-LEFT-for-Nissan-Terrano-86-97-MD-WD-21/113015006045?hash=item1a5038235d:g:P8MAAOSwdoJbNP6L

Whilst I was there I replaced the drop bushes on the ends of the stabilizer bar as they had separated and I was getting a loud clonking on steering lock.

My brake warning light came on so I took off the wheels only to find both the caliper's & brake carriers on each site ceased solid, even managed to brake the tops of the sliders off on both caliper carriers. Both looked like a cut dried out onion with the amount of rust layers. I'm sure they...

?? we are talking about the same thing. :nenau remove the Hub assembly and bearings behind which is a dome with a small seal around the inner edge, undo the 4 bolts (2 top, 2 bottom) this also hold on the baffle plate/disk cover. Shown as grease seal B on the workshop manual for the front...

Got over to Nissan today and yes the Grease seal B is available at £19 +vat but I had to give them the REG of a Terrano which I looked up on Fleabay. I've ordered one for each side. The brake baffle plates (Disk protectors) i'll have to get from a breakers at some point from a younger truck.

Just been upgrading my front brakes (Disks, Calipers, Sliders& Pads) but thats another story. Could anyone tell me if you can still get the Baffle Plate & Grease seal that sits behind the disk & Hub assembley for a Ford Maverick 1998 or can I use a second hand one from a later Terrano as mine...

Thanks Rick, Tried both methods still no luck (1998 model) retreaving the code. EML on permanent. I even blew a fuse trying :doh

Right tried the paper clip in the grey block under the dash to get the fault code but no avail. When the ignition was turned on the EML just stayed light permanently (No Flashing). Don't know if I'm doing it correctly? bottom First and last pin in the block. Reading the manual it says it could...

Hi all I had just finished a 70 mile motorway trip when I Noticed my EML had come on. The truck seamed to run ok during the trip and it ran throughout the day and on the return journey. typical as the MOT is due this month. Started it today and it idles ok. rev it to about 2000 rpm and it has a...

Bloody hell that was quick I did not even have time to refresh the page. Thanks Banshee will take a look and update asap. :thumb2:bow

Hi all, this is my first post even though I have been a member for the past year and owned my truck (Ford Maverick 2.7 TD SWB) for 2. My issue is starting the engine turns over very slow and eventually starts. I have replaced the battery recently as a cell gone and the amp were low. Any ideas on...