Search results

I have just replaced the battery on my truck too :(:(:( Just gave up one morning (only about -7 degrees) and that was it! After much looking about managed to get a huge EXIDE super dooper all singing and dancing high power jobby from Euro car parts. Tried Halfrauds and local shops but all wanted...

Hi...my T2 also has these little rubber pipes coming off the top of the injectors and following a whiff of diesel when I turned it off last night I had a look (with a torch) and the rear injector looks wet on top??? It is under the intercooler so not easy to get at..... what do these pipes do...

Does anyone know where the wiper relay uniy is for the front wipers? I am still having problems and although I think it is the motor I am not sure.... now if you use the delay, slow or high speed setting the wipers do not switch off until I stop the truck and turn it off... OR.... sometimes it...

Thanks...is it a strip and repair job or bin it and get another?????

If you look in the 'download' section from the main home page there is one about removing the hubs and discs.... shows the bits in there

If I remember rightly you need to jack the front up, take the centre cap off, then the hub centre (5/6 small bolts and a snap ring) then there is a retaining ring held in by 2 small screws. Take that off and then the wheel bearing is adjusted by turning the big centre ring (that is the terrano...

Porsche?????.........lol..... reminded me, nearly got taken out this morning by a VERY blinged up BMX X5 with blingy wheels and low profile slicks going very sideways on the ice towards me and looking terrified !!!! Just pulled over on the pavement (cos I can ;););)) I know I am a 'towny' down...

Well.... I have done the following but still not sure of the fault??? Firstly tried the 'flick' wipe but it just stops as soon as you let the lever go... Secondly I tried the wash/wipe which washes and wipes but does not stop wiping!!!!...thirdly tried the normal wipe (delay just works like a...

Thanks Rustic... I will go out and try it in a while.... I will have to buy new parts so the 'modular' method is fine but not so when I gotta go buy them :eek::eek::eek: Would be good to actually pin it down to one part;)

2002 TDI model...... IS an all doing switch on the right side of the steering column, has delay twisty thing on the end... hope that helps

Hi New to 4x4's but the terrano has been a godsend these past few days with all the snow in the south east... however was out in it yesterday and a bloody great lump of snow shot off the roof onto the wipers (which were on) and stopped them dead in the middle of the screen!! Stopped the car and...

Well with the bleed nipple open on the slave cylinder I can just pull/push the pedal up and down by hand! No resistance at all....... I am now warm again (its jolly cold out there laying under the car) so will follow the advice in the workshop manual and bleed from the back of the car then do...

Hi just tried to bleed my cluth pedal (as It feels a bit low and you can 'pump' it up to a good pressure by pushing it a few times) but as soon as I push the pedal with the bleed nipple undone the pedal goes to the floor and wont come back!!! Does anyone know if there should be a spring on it...

Mine too does this if I use the keys.... reading the handbook I think it is supposed to do it !!! Something to do with the security system but not good for the neighbours at 6:30 in the morning !!!

Thanks for all the advice here..... took the thing apart on Tuesday night, found a local motor factors who had a pump and matched the fan to the thing and hoorah.... it is the 143mm one so bought it :clap.... Finished the job off yesterday afternoon. Did it with radiator in situ, a bit fiddly to...

Just off the phone to Milner ansd yes there are 2 sorts !!!! Apparently I need to measure across the viscous unit bolt hole to bolt hole.... lady says will likely be the 143mm one but need to measure to be sure :confused::confused::confused: Looks like a late night under the bonnet when I get...

I have also just changed mine using the diy stick together method!!! Excellent bit of kit if you take your time and keep it all very clean (never easy given where it is situated) however an hour or 2 a side and hey presto new cv boots and new grease :clap:clap:clap:clap I did buy the 'take the...

Just checked Milners and they quote 2 on their web page!!!!!!!!!!!! http://www.milneroffroad.com/categories.asp?cID=12456 Seems the viscous unit can be either 143mm or 135mm across :doh:doh:doh I will call them and ask as one might be for a Terrano and one for a Mav by their description ...

Thanks for that.... I will call Milners and ask. I see a lot of people use them on here.... I wasnt aware of 2 sorts either (workshop manual only shows 1 for the 2.7 tdi) but Didnt want to end up stuck tbh... It only just started to leak yesterday, very odd as it just ran out for a couple of...

Hi I need to replace the water pump on my 2002 2.7tdi mav....However whilst searching the web for prices I find there are 2 different ones which look the same?? Looks like the viscous unit is a different size on both...... Also seems that 2002 was the year it all changed! Knowing my luck I will...