Search results

brutal 4wd track. 4 hours of non stop broken drive lines bent steering and dinged up panels.

Grab the pitman arm from a 91-92 nissan ute/navara/terrano/pathfinder etc with the large spline but small taper and the steering setup out of a 2wd navara then you can get your self some of these badboys made up.:D

and that's the point of the upper control arm it allows the same amount of travel as it was before you "reindexed" your torsion bars as apposed to winding them up it will allow the same amount of twist in the rod instead of compressing all of its ability to the high end. It allows the same...

the calmini kit basically drops the entire front drive line down lower. It is designed to keep the front CV's within operating spec (max 35 degrees) from memory. all you want to do is get longer upper control arms. you don't want ball joint spacers this wont fix the issue with the angle on the...

I was thinking about this today Alex as i sat trying to change the ball joint(again) in my T2. You'd not only have to chop away all the existing mounts and build up spring seats and shock mounts but also the sump on a TD27 may need some alteration. Don't worry about the radius arms, you can...

depends if you have a left hand drive or right hand drive

Same principle as a band saw in a Saw mill...and resaws..(which is what I do) THe saw will need tracking to run true.... it could have a crook /worn bearing which will create more pressure on one side of the band then the other causing it to move forward of the wheels.

line pressure solenoid. This is the part the forces the clutch packs together to transfer drive from the planetary gears to the sun gear that drives the output shaft to the transfer case. it maybe sticky, there maybe some gunk stuck in it. Strongly recommend getting it flushed...

ummm paint them?

RD28? perfect time for the RB25det bolts right up.

The bosses wife was in the car?

Alex most nissan's with wide body or flares from factory run factory negative offset, patrols, R3m terrano pathfinder, etc and by the looks of your rub you only need 10mm or so to fix the issue so a set of factory safari/patrol rims with a minus 18 or 22 offset would be fine.

new steel rims are cheap, why not just buy rims with a bigger offset?

6ml steel plate, should have doubled it.

ego needed a bandage, otherwise fine.

Had a "oh Sh*t momment hit a tree. not to serious though. Bar took most of it . https://www.youtube.com/watch?v=jJyORGFaJ0I&feature=youtu.be

yep, H233B.

look on the build plate axle code HG** etc