New Trusted Supplier - japanese4x4spares.co.uk

Blocky10 said:

Now I've been fortunate enough not to have had any problems with Milners and I now wish to purchase a poly bush kit for the rear axle.
Milners sell the complete kit plus the panhard bushes for £99, which includes £6.50 postage.
This place sells the same kit but minus the panhard bushes for £134.50 with free delivery.
So in this instance I've got to go back to Milners, haven't I?

Click to expand...

Lazy-Ferret said:

Can you say what the part number and price are on that bit Zac, Suz's car's flexi has gone and the rest of the exhaust is still silver, so if I could just replace that bit, it would be a lot cheaper, and less work hopefully.

Click to expand...

Banshee said:

That is a bit of a price difference, but if you don't ask you don't get, give them a call and say you've spoken to me and you're from the forum and see what they can do for you :thumb2



The flexi is made my Klarius and the part number is FRP13K A60197

Click to expand...

Lazy-Ferret said:

Did you ever fit this in the end Zac?

I got one for Suz's car, but where ever I position the rear clamp, it bangs against the cross member when the engine is running. Looks like the only way to have enough clearance is to weld it in place. but as I then have to remove the whole front assembly, I might as well buy the complete assembly ready made.

Click to expand...

Banshee said:

It's on the truck now and works a treat, I did find that at idle sometimes there was a slight rattle somewhere, it turned out that I just had to spin one of the clamps around as it was catching on the front prop

It's been fine since :thumb2

Click to expand...

Lazy-Ferret said:

Cheers.... I need to basically lift Suz's exhaust up so it sits higher under up, nearer the body floor pan, but I can't see any way to adjust it. The "U" part of the clamp only has about 5mm of clearance above the cross member, and as it is, it runs through the mounting on the gearbox, so if I raised it any higher, it would be above that mount.

Click to expand...