dave123
Well-known member
- Joined
- Jun 4, 2013
- Messages
- 519
hi all I need some advice and help . I have been trying to raise the front because they have been hitting on the rubber bound bump. so I done it like it says in section fa9 and fa39 of the workshop manual download which tells me that the vehicle posture should be 32mm . i have managed to get it to 30mm both side from 15mm. but the drivers side front has a 10 inch gap between wheel arch and the rim and the rear driver side has 12 inches . on the passenger side it is 11.5 at the back and 10 inches at the front . but should I ignore what it say in the workshop manual on how to set it up and set the gaps the same or just leave it . somebody had be messing around with it before me because on the torsion bar adjuster you have the 2 nuts to lock it off they where loose and it has now sorted out the notchy feeling when turning slowly