O.K this is getting strange

[R1cho]

Good luck, remember how the brakes fit back together, springs everywhere....:lol

erm whers this bit go?

:lol

 

[rustic]

erm whers this bit go?

:lol

I could tell you:

but I think it could be a "Bog standard" part.:thumbs

Well you did take the plunge and splashing out on new parts.:lol:lol

 

[R1cho]

I think if i use that in the breaks the car will go straight down the sh***er

 

[R1cho]

ok collected the new cylinder, went to fit it, its the wrong fooking one, it looks like its the right one but the fitting at the rear of it is to big to fit in the old slot:doh, damn it back to the parts shop i go.

 

[rustic]

ok collected the new cylinder, went to fit it, its the wrong fooking one, it looks like its the right one but the fitting at the rear of it is to big to fit in the old slot:doh, damn it back to the parts shop i go.

How far are you from milners, or will they be shut now?

 

[bobhope]

if your near burton on trent . I use a motor factor called Foreign Autoparts . only deal in jap parts ,used them for years and they know what there talking about . if part not in stock will get in couple of hours .

 

[R1cho]

well the replacement wont now be in stock until monday so as i cant be without transport i have decided i'm going to refurb the old cylinder until i can get the new one, easy job pics to follow

 

[R1cho]

ok no pics my hands were to dirty lol however the cylinder just needed a good clean, stripped it down and checked all rubber seals, everyting ok, given a good clean and put it back together, back on the truck, tested brakes went for a drive round and so far so good, will check them again in the morning to make sure there are no leaks, still going to get new cylinder but at least i wont have to fit it straight away. :clap