non start fault codes

[jw2106]

ok folks have changed clutch and that is now good ...however started her up and let run for a few min ,turn off will it start again will it heck....so had a look injector pump has a quiet buzz with ignition on (is this normal ?) glow plugs only power up for a couple of secs (all plugs are good) if i crack injector pipes getting no fuel there ,stop solenoid tested and working. oh mil light was on when it was running so pulled codes its quite a list see below any ideas where to start please people.

12- maf circuit malfunction
13- engine coolant temp sensor circuit malfunction
17- module coding plug circuit malfunction
18- fuel quantity adjuster/position sensor malfunction
23- accelerator pedal position switch-incorrect signal
34- injector lift needle sensor -incorrect signal
43- accelerator pedal position switch-incorrect signal
47- crankshaft position sensor -incorrect signal

ok thats them all and could do with getting the bugger running all help gratefully recieved
jason

 

[rayf3262]

ok folks have changed clutch and that is now good ...however started her up and let run for a few min ,turn off will it start again will it heck....so had a look injector pump has a quiet buzz with ignition on (is this normal ?) glow plugs only power up for a couple of secs (all plugs are good) if i crack injector pipes getting no fuel there ,stop solenoid tested and working. oh mil light was on when it was running so pulled codes its quite a list see below any ideas where to start please people.

12- maf circuit malfunction
13- engine coolant temp sensor circuit malfunction
17- module coding plug circuit malfunction
18- fuel quantity adjuster/position sensor malfunction
23- accelerator pedal position switch-incorrect signal
34- injector lift needle sensor -incorrect signal
43- accelerator pedal position switch-incorrect signal
47- crankshaft position sensor -incorrect signal

ok thats them all and could do with getting the bugger running all help gratefully recieved
jason

Full house.....
That little lot almost suggests the ECU is not connected! But I doubt that...
Start by clearing the fault codes and then see what returns.

 

[jw2106]

i know shocking aint it , which ones would stop fuel getting to injectors??

 

[rayf3262]

i know shocking aint it , which ones would stop fuel getting to injectors??

With a list of FC's like that you need to start by clearing them FIRST, then you may get some useful FC's Back. When you have, post what returns.

 

[jw2106]

ok thanks will have a look tommorow after work and post up results