New Middle and Rear Exhaust

[KillerPete]

Just had a new middle and rear exhaust sections fitted, old middle had gone at the box and rear not looking to either, cost just short £100 fitted.

However (and there is always one of them) when the thing went in the first place it looks like it damage what I can only think is an axle breath pipe. I have a pipe what appears to be at one end attached to a cross member and the other end is dangling down, I can only think that this end was attached to the back axle.

Anybody had this happen, and what is the best way to sort it?

Cheers

Pete.

 

[Deleted Member S]

If it is the breather pipe on top of the axle there should be a little pipe coming out which the rubber tube fits onto, you could either just replace the pipe & refit it to the x member or fit a longer pipe & run it along the floor & up into the engine bay which would be the best thing if you think you may go into deep water some time

 

[KillerPete]

Hi sweety,

Its the little steel pipe that the rubber hose fits onto thats broken of from the top of the rear axle. Not planning on going in deep water at the moment but who knows. Will have to get under and see what I can do.

Cheers.