ok,i had the same problem when i introduced the t2 to wvo, after about 30mls,on wvo.mix.every time it played up i would pull over and it would cut out,then it would restart and it would do the same,i did all the filter changing etc to no avail.i knew it was a fuel issue but after many many attempts to get to the bottom of it i put a video camera pointed to filter,attached to a screen and drove untill it started to happen,it did,not suddenly but a gradual loss of power untill it cut out.watching the film it showed the primmer plunger slowly being sucked down untill it was down,this cuts all fuel to engine but on stopping and inspecting the plunger was up so it would start.
phew.i bypast the filter and put a large inline one in and it was better but not perfect.
in the end after weeks of trying things i have done this and since no more trouble.
forget the built in filter unite.
use a large inline clear filter,take out the fuel sender from the tank and remove the swerl chamber from the pick up pipe(not got a filter in it but small holes and not letting enough fuel through)extend the pick up or you wont be getting all fuel from the tank.
i put a 10mm pipe from tank top to the across the bulkhead pipe that goes to the filter,then the clear inline one just down at one end from horizontal to act as a water trap,then a lift pump right at the ip feed in and walla its been ok since.
i have found i have to mix my wvo with rug/derv out of the tank as when i filled up with wvo neat it sank at the bottom,started ok but then neet oil got sucked in and took a long while to keep it going.so now i mix out of car.
i am using 25/75 rug/wvo or 25/75 wvo and that is ok for mt t2.but i will go to 50/50 in constant freezing.
i leave my mix out in open in clear pop bottle so i can see any gelling.
hope this helps.
all my previous cars i mixed in the tank but this i mix out.