illy said:
Just solved the problem, it was a 1 1/2 amp drain caused by the Richard Cranium that fitted the radio. The power wire and the memory power wire had been twisted together and in turn been connected to a wire under the dash. Don't no how this works but it caused other equipment to be left live, hence the 1 1/2 amp drain. :?
Tony
The problem was caused by the supply to the radio back feeding the system as the supply to the memory is live all the time.
At best it would cause a fuse to go, at worst, you could have burnt out cables and caused a fire, especially if fuses were blowing and people then put bigger fuses in. The weakest link will then be the wire it's self.
As a precaution, I would check the values of all other fuses in your fuse box, just in case. I think you have had a lucky escape, and I wouldn't use that same radio fitter again.
A quick way to detect a power drain like this is to disconnect the battery and fit an ammeter in series with the lead, say set to 10 Amps, then remove fuses one by one.
The problem with this is that you will loose the radio code, engine settings and may interfere with the alarm/imobiliser etc.
Also you may cause a short circuit if you are unsure of what you are doing. So CAUTION.
I used this method on my daughter's Fiesta and located the fault to the alternator and then the diode block within it.
Hope this helps and is a caution to other owners to check their vehicles for added wiring and fuse "upgrades".
Best regards, Rustic