zephyr
Well-known member
- Joined
- Sep 29, 2016
- Messages
- 154
I am assuming that you know the wires for the power feed, the lights and the earth so you are talking about the white cable marked Headlight / Dashboard.
As my relay is mounted on both vehicles on the inner wing panel near the headlights I decided to find the headlamp wiring and connected the white cable to the wire that powers the dip beam. As the relay power is very small you can either use a Scotch Lock or if you prefer cut through the wire and use a connector to join in the white cable. On my BMW I used a Scotch Lock and then taped up with decent self sealing insulating tape. On the Jeep there was plenty of space so I used a crimped male/female connector with two cables on the male side and the female on the dipped beam feed. Again I tapped up the whole connector with the self sealing insulating tape.
Thank you - this gives me an idea of how I could do this. I will sort this out and hopefully I'd be able to report the results!
:thumbs