3 Ltr cut out problem

[solarman216]

Hi all it is not often I need help but the Mrs 3Ltr has started cutting at low speed but starts instantly after, the Mil light comes on briefly but goes off normally after a restart, I got an OBD2 reader but it does not work on this motor, I seem to remember Rayf commenting on this in the past, however with the odometer buttons and the ignition switch I can get the codes via the odometer display, problem is I cannot find out what they mean, I am not even sure that they are fault codes, they could be build codes, I await someone more knowledgeable on the 3 than I, Rick

 

[RobN]

Rick,

Sorry I took so long.
See thread: http://www.nissan4x4ownersclub.com/forum/showthread.php?t=21534
Post codes and I will see what I can translate.

Rob

 

[solarman216]

Thanks Rob but seems sorted, one of the codes obtained by the old paper clip method was throttle related and I had my suspicions anyway, and as I had a spare on the shelf swapped them over, and it has performed fine since, Rick