Search results

code says the sensor, read the thread that was linked, will try and induce some back pressure, see if that helps. Thanks for all your help.

i've finally read my codes and the only code becoming active causing the stalling and misfiring is number 18 Fuel quantity adjuster/position sensor - malfunction. any ideas or places to look? worrying like an ECM problem. thanks in advance

switch is up the swanny, thats for sure, not the cause of the fault, but is still trouble, need to know what wires are actually for power to the starter motor, i have a pulse switch here that i'll fit if i know where to fit it, which wire is which? all help appreciated.

Can anyone post a picture of what an ignition switch looks like? Thanks

Not checked the code yet. But drove it a bit today around the farm, Kep hearing a whirring noise from behind the dash. Presumed it was the cd player spinning as the some times do. Now thinking it was the starter motor spinning, but the solenoid to putting the bendix accross. If this were...

Sweet, got myself a new paperclip and all.

Codes is a funny one, the mil light goes on, then when i cycle the power to restart the truck, the mil goes out. Will the code be stored?

Following on from previous posts where i've had some help, i am still having starting and running troubles. But the types of trouble changes all the time. Today i replaced the battery cables and checked the alternator and battery. All came up good. But still sluggish to start, i'm now master...

Had several codes and its one of them. Have pretty corroded leads too and its a crap starter, so need to do them too. Easter weekend perhaps.

Truck running rough. Stalling mil lit on constantly, at that money it would have been worth a punt to see if it improved it, done pretty much everything else to it

I reckon i need a crank sensor on my truck, saw this and was waiting to see if i could confirm it was the right thing http://www.ebay.co.uk/itm/FLYWHEEL-SENSOR-for-NISSAN-TERRANO-2-7-TDi-/271166319233?pt=UK_CarsParts_Vehicles_CarParts_SM&fits=Model%3ATerrano&hash=item3f22c5aa81 Have i missed a...

Cheers rick, i'm in chelmsford, i'd love to take you up on the offer but the truck is on thewest cost of ireland! So i'm solo i reckon

Gents, thanks for all your help so far. Still have the running issue, no codes stored, but i suspect that could be wrong. Still suspect the ckp I have pulled the truck out for a few days now, not been used since saturday. I have a whole fresh batch of problems, now started to overheat, but...

I'll have to double check, I had it off cleaned and bought a replacement, so you'd expect me to know! Its a 1997 round headlight model with a scoop, pretty certain it has an intercooler. Edit. Pretty sure it's this one http://www.expressauto24.net/Mass-Air-Flow-Sensor-22680-2J200-Nissan

Bosch I think.

Cheers for that. Will look it up. Just as a bit of further info, my cousin is driving it at the moment. His comment was, once it's going to stall, that's it, push the clutch in or give her a rev makes no difference it'll stop like someone has switched it off.

Just looked on downloads can't see any instructions. Canyons point me in the right direction.

Bang on. Cheers. Starting to think it might be the timing, so maybe the crankshaft sensor is my kiddy, will read the codes in a fortnight and report back. Thanks

Yeah that's the one.

An orange light For the engine comes on, it's on the left hand side of the dash, is that the same light.