Search results

Thanks Jim I will try to get some photos but the mechanic showed me the damage when it was on the ramp and although it could be done by someone who an do their own welding, I don't think it would be economic to pay someone to do it. It really is a pity because the car is so good mechanically...

Hi, I have just got my wifes 1999 Terrano 2 back from the garage where they were going to do some welding repairs to get it through the MOT. Unfortunately, the mechanic thinks that is a waste of time doing the welding as it is so extensive. So, the car is great other than the rust, I am looking...

Thanks to everyone for their help-much appreciated!!

Hi, after removing the fuel line do I just remove the top section ie the smaller of the two hexagons? Thanks for your help. fred

Would appreciate any tips / advice re removing injectors from a Terrano. I have one that is leaking between the two hexagons, Thanks Fred

Hi Rick, just been out to it again-the leak is from the seam just above the larger hex(so between the main body of the injector and the hex where the run off pipes are).

Hi Rick-thanks for the advice! Must be No 4 (nearest the bulkhead) as there is only one pipe and one sealed off. The leak seems to be from the injector itself as the leak is below the pipes- as it doesn't start leaking until the engine warms up I am wondering if it is the injector seals??

My V reg Terrano 2 has developed a leak at No1 injector- we have had problems in the past with mice chewing the by pass pipes and initially thought that all I had to do was replace a pipe!! Anyway nothing so simple. When I started the engine from cold there wasn't a leak but as the engine warmed...

Thanks for letting me know.

Hi, does anyone know where I could get a rear floor panel for a terrano please? thanks Fred

I have a Terrano 2 1999 which has a "sticking clutch pedal". By that I mean that it doesn't always fully return-sticking half way up and needs a foot behind it to return it to the normal position! Is this simply a matter of bleeding the hydraulics or is it likely to be more sinister that that...

I have taken the fuel tank off to get access to a leak and it could do with replacing-does anyone know where I could get a replacement please. Whilst under there I have decided to rust proof the underside. I have been cleaning it off witha wire brush and have now got rid of the loose rust and...

Hi I have spotted a leak from the fuel pipes on a Terrano 2.7tdi V reg. Upon inspection they are in need of replacement right through. Please could anyone advise where I can get replacements other than from main dealers and if there any pipes available that can be bent to fit available??? Any...

Hi, my Terrano 2 2.7tdi 1999 has just failed its MOT on spongy pedal and uneven front braking. I have discovered that the discs are in need of replacing as are the pads. Could anyone please advise how to tackle this job-are any special tools required-removal of hubs etc---- Any advice would be...

Terrano 1999. My wife has managed to get the key stuck in the door lock! She did manage to open it but now the key won't go clockwise to lock it and won't come out. I suspect it will need a new barrel but any instructins on removing door panel-eg does the electric window switch pull off?

A big thank you Thanks to everyone for their help in this-it sounds like I have got a duff key in one way or another - I may have to get on to their auto specialists-thanks again!!

have justb tried opening door with the original key and then put the new key(no buttons) in ignition but it does not cancel hazard warning lights flashing-it will turn the engine over but will not fire. As soon as the original key is used it works as normal! I wonder if the new key has not been...

Well as I say the guy in the shop copied the transponder code onto the new key-but the engine won't fire. Does this mean that the new key is at fault? He reckons that some cars need a procedure followed before the key will start the engine ??

Yes thanks! I saw that thread but this is not a remote central locking key just the old fashioned manual!!

Hi, just had a key cut and supposedly progammed at Timpsons in Goole.The key will open the door and turn the engine over but it won't fire. the original key starts it immediately. Rang the shop and the guy says that some cars need a procedure carried out and advised to check the handbook. The...