Winch bumper

[manora]

I've done 3 now and driven them all hard :sly into trees, rocks and the ground. Winched mine all over the place no issues. 4 bolts into the chassis where the bumper bkts once were, simples
The holes under the chassis I used as a bolt on position for my bash plate. That's then bolted to the bumper, so it is triangulated too

That's sort of what I was planning but with more reliance on the chassis bolts. I do tend to be a bit belt and braces but in light of the comments above I will look again.

Peter

 

[stinka]

Just picked these up from my mate

Begging some more 6mm sheet next for the winch plate, bottom bash plate, and a few gussets which shall go between these 2, will weld a length of 50x50x3mm across behind the
Bash plate as well

Then I'll template the corners out of ply, and I'll carefully cut them from 3mm and mig that part

Just got to find time as I'm super busy at mo !