Track rod endGunson Trakrite Magnetic Alignment Camber Castor Gauge Race Rally Garage

[glen]

Just changed track rod end at front inner Think its been on since new tight Nuts on ajuster and the taper shaft solid used blow lamp for about 20min took some getting off but done did count & measure the threads used tape to messure, Not sure about the chamber so any body used the thing below £20.00 on ebay Not sure how it works but you can put on hub or brake disic car needs to be on flat

Gunson Trakrite Magnetic Alignment Camber Castor Gauge Race Rally Garage

Glen

Ps I know a good tyre man he is good at tracking Last time I used 15 Quid

 

[R1cho]

Just changed track rod end at front inner Think its been on since new tight Nuts on ajuster and the taper shaft solid used blow lamp for about 20min took some getting off but done did count & measure the threads used tape to messure, Not sure about the chamber so any body used the thing below £20.00 on ebay Not sure how it works but you can put on hub or brake disic car needs to be on flat

Gunson Trakrite Magnetic Alignment Camber Castor Gauge Race Rally Garage

Glen

Ps I know a good tyre man he is good at tracking Last time I used 15 Quid

good whack with a big hammer and the taper usually just pops out

 

[glen]

Well seized

I used a fork splitter large lump hammer, heat,dismantling liquid stuff from work kept hiting nut on top left over night, new day put heat on again for a bit longer 20 Minutes yes it dropped then the thing was spining so I used a electric saw for the Nut thread bolt because all the hiting made the nut tight

Glen