Teranno Gear Box Lose of Drive

[FrankSnr]

Hi, I have a Teranno 2.7TDI 2000 - Can anyone help, I have lost all drive both two and four wheel drive? is there something borken, its was running very well on the main road and I stoped at a junction, put it into 1st gear let out the clutch and the veh did not Move.

I have taken the Teranno to my local garage, however I would like to know if anyone else have had the same problem?

Thanks Frank

 

[zippy656]

very daft idea...

youve not had a kid kick the 4wd lever into nutral have you.

Mind did that to me a while ago

 

[lacroupade]

very daft idea...

youve not had a kid kick the 4wd lever into nutral have you.

Mind did that to me a while ago

Good point, make sure the 4WD lever is as far forward as it will go.

So Zippy, "mine did that to me" eh? I think you meant "I did that to mine" didn't you?! LOL

 

[FrankSnr]

Hi Zippy,

Checked four wheel drive lever a few times, it's had no effect, its like if the gearbox is stuck in nutral.

Thanks Frank

 

[zippy656]

clutch fluid level ok??

 

[DEE]

Sounds like it could be the thrust bearing gone through the presher plate :doh Let hope it is not as bad as that though

 

[FrankSnr]

Thanks everyone,

The clutch fliud level is fine, so I am starting to think that it must be the thrust bearing gone through the presher plate, I will let all know when I have more news.

Again thanks for your help.

 

[Timbo_1975]

with the clutch released, can you hear any layshaft rattle (indicating the innards of the 'box are turning) ???

Will be slight change of engine note too.

 

[FrankSnr]

Timbo thanks,

Don't remember any rattle from the innards of the gearbox and or change to engine note?

some one who works for Nissan told me it is most likely to be a problem with the clutch thrust bearing. The Car is in the local garage at the moment, I hope to have some indication of the problem on Monady next.

Thanks Frank

 

[lacroupade]

Timbo thanks,

Don't remember any rattle from the innards of the gearbox and or change to engine note?

some one who works for Nissan told me it is most likely to be a problem with the clutch thrust bearing. The Car is in the local garage at the moment, I hope to have some indication of the problem on Monady next.

Thanks Frank

Keep us posted Frank...good luck, fingers crossed for you.

 

[Toolbox]

It’s quite a common problem for the centre of the clutch plate to rip out.

 

[FrankSnr]

Toolbox thank you.

Frank

 

[lacroupade]

Toolbox thank you.

Frank

...he said with his head in his hands.... :thumbs

 

[FrankSnr]

Dear all,

Toolbox thanks your right, it was that common problem for the centre of the clutch plate to rip out. The Local garage cost of fix £506.

Thanks everyone - Frank

 

[FrankSnr]

Dear all, Just had the car back with new clutch plate £506, all is well now.

Thanks

 

[lacroupade]

Dear all, Just had the car back with new clutch plate £506, all is well now.

Thanks

Ouch! Thats a bitch, but one less thing to worry about I suppose, and there aren't that many really serious things so, hey-ho, onwards and upwards!:thumbs

 

[DEE]

eeeeeeeeeeeh them there thrust bearings :doh Glad to see you are sorted