Rear windows actuator

[lo_zarro]

i guess they only come with the screen, not as a spare itself..

but don't try to remove from a glass.. in that case just take some dimension so i can create the 3d model and print it

 

[Banshee]

i guess they only come with the screen, not as a spare itself..

but don't try to remove from a glass.. in that case just take some dimension so i can create the 3d model and print it

That sounds like a plan mate, I'll check my glass stock when I'm home

 

[lo_zarro]

hi mate! do you have any news about it?!

 

[Banshee]

hi mate! do you have any news about it?!

I looked a good few days ago for you mate and just totally forgot to post :doh

It does look as if they are a one time deal, you'll get them off no problem, but I'm 99% sure you'll snap them as they come off and if you do get one off you'll struggle to get it back on and stay unless you use lots of resin/sealant etc like Tigerseal (makeitfits favourite)

I'd suggest that it would be easier to actually swap the glass out, when I went up into my parts storage area, I noticed that the 2 sets of glass that I have up there are factory tinted :naughty :naughty

Might pop those in the new truck :nenau

 

[lo_zarro]

thanks!
my idea is to have a couple of them to take the dimensions and try to replicate with a 3d printer.
for sure, swapping the entire glass is the easiest way, and it's definitely an option. but trying to replicate the broken parts is more interesting!
anyway, i'll have the 3d printer available just for a couple of weeks, then i'll change workplace!