Power steering pipes

[PJD]

I am looking for a set of power steering pipes. I have a leak and I can't trace where it is coming from. Also my pas belt snapped (pump didn't seize just an old belt that perished) and I can't figure out how to change it! Any help would be greatly appreciated! Cheers

 

[jims-terrano]

Pipes are dead easy. Remove the rubber u shaped hose from the two ends on left hand side. Shorten the two pipes and stick the rubber pipe on. Have done it on mine and have not had any heat problems. They normally rot out where the steel clamps hold them to cross member.

As for the belt take a look in downloads section to see if the water pump how to guide shows anything. I’ve never done it but I’ve been told not that bad to do.

 

[kitchenman]

The mini filter guide should help, workshop 10 I think. this shows how to move the steering pump and adjust it

 

[PJD]

Pipes are dead easy. Remove the rubber u shaped hose from the two ends on left hand side. Shorten the two pipes and stick the rubber pipe on. Have done it on mine and have not had any heat problems. They normally rot out where the steel clamps hold them to cross member.

As for the belt take a look in downloads section to see if the water pump how to guide shows anything. I’ve never done it but I’ve been told not that bad to do.

Thanks mate