Pedal removal and CPS

[AlexD333]

Hi chaps, top of the morning to ya *hats off emote*

How difficult is it to remove the throttle pedal? (want to clean the connector and test)

Also the crank position sensor I want to change as have no aquired one. Seen above bell housing, heard I/C removal needed but is there a step by step guide for dummies? :augie

 

[Madmark]

Could you get to it underneath bud as ten mm bolt and wiggle it out

 

[AlexD333]

Could you get to it underneath bud as ten mm bolt and wiggle it out

Like bend arm round bellhousing and feel for it?

Plenty of room if i put it in the pit at work :naughty

 

[bry]

Never done the 1st. CPS easy peasy.

 

[Madmark]

I reckon easy too as our trucks have body lift so even more room

 

[AlexD333]

I reckon easy too as our trucks have body lift so even more room

Right ok, thanks chaps, I will see if I can get underneath it and wrench my poor arm above the bell housing then :thumb2

Any thoughts on the pedal? :augie

 

[makeitfit]

Pedal is dead easy. 2 or 3 10mm nuts on the floor under the pedal. Simples

 

[AlexD333]

I've had the Maf amp in now for a few days, drives with more power, my symptoms are still here though... Occasionally gutless or laggy from take off or slow crawl, any suggestions let me know...

I will try and clean pedal today at work :thumb2