LWB rails on a SWB

[Fez_uk]

Just finished putting these on, Didn't bother with riv nuts as I think nuts + washers will be stronger.

Sealed with tiger seal with the old rubber seals, Could of done with better rubbers but should be fine. Added a bit too much sealant so have to clean it off.

Now I can get on with adding spotlights and antennas.

:thumbs

 

[96terrano]

That looks good.:thumbs I always wondered what lwb rails looked like on a swb. I was thinking of doing that when I had a swb:thumb2 it looks cool :naughty:clap

 

[96terrano]

Ps.. I never knew you were a member of raynet. So am I

 

[Fez_uk]

Ps.. I never knew you were a member of raynet. So am I

Cool, We are quite busy down here. Just did a offroad motorbike enduro last week.

 

[Adz]

:thumbs :clap

 

[makeitfit]

Got there in the end then
Good job :thumbs

 

[96terrano]

Cool, We are quite busy down here. Just did a offroad motorbike enduro last week.

Cool:thumb2

 

[Fez_uk]

Attached the roof lights today aswell as antenna mounts. All needs to be plumbed in once I get the snorkel on. I may bring the bar more forwards.

 

[makeitfit]

Good job mate:thumbs coming on a treat

 

[lacroupade]

Good job mate:thumbs coming on a treat

you're only saying that cos it looks exactly like yours on the roof now LOL!

Its those hideous square foglamps that do it you know :doh

Seriously though Fez, nice job mate.:thumb2

While you're there, post a pic of your dash camera mount would you and tell me where you got it? cheers!

 

[Fez_uk]

not exactly the same

As for the camera mount it's one of these, took the rubber off and just screwed it to the dash.

Can't seem to find a active listing in the UK for £5 on these right now, odd.

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=180637711535#ht_2391wt_1139

 

[lacroupade]

not exactly the same

As for the camera mount it's one of these, took the rubber off and just screwed it to the dash.

Can't seem to find a active listing in the UK for £5 on these right now, odd.

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=180637711535#ht_2391wt_1139

cool - and what meat was there to screw it to the dash with? Did you just use self-tappers? And where exactly did you stick it?!

Krist I sound like your doctor LOL

 

[Fez_uk]

I just used some small screws and positioned it where the camera would clear the windscreen when on and when any vibration offroading.

Then just screwed into the dash, through the spongy grey stuff into some plastic below.

 

[lacroupade]

I just used some small screws and positioned it where the camera would clear the windscreen when on and when any vibration offroading.

Then just screwed into the dash, through the spongy grey stuff into some plastic below.

You're a pretty 'devil may care' type of a bloke aren't you Fez LMAO!

cheers m'dear, I'll give it a pop.:thumbs

 

[96terrano]

Yep!!, I like that:thumb2