loosing my bearings

[keeny]

how do i adjust front wheel bearings on my terrano n reg, i can wobble my
wheels by holding from top to bottom but not severe, oh is it possible to
fit a 2.4 pet engine out of a 95 model into a 202 model. many thanks....
:smile: :wink:

 

[elty001]

bearings

if you remove the hub unit(6 allen bolts)then remove the circlip from the shaft and pull off the big cupped washer you will see a disc with holes which should have 2 screws holding it in place.this is the adjuster nut.remove the 2 screws and you can then tighten the disc to adjust the wheel bearing.i tightend mine as much as i could turn it(but not over tight)then backed it off a touch until the holes lined up for the 2 screws to go back in.make sure its nice and free with no noise or tight spots then put it back together.while you have got the hub off it would be a good idea to grease it up.dont overdo it though just a light coating of grease will do.
hope this helps you out a bit. :smile: