leak off pipe

[John B]

Hi all I've had the truck now for two and a half years and have had to replace the leak off pipes twice already and now need to do them again so could anyone of you peeps give me a bit of advice as too which pipe is best and also the inside size please ?? I've seen some on ebay but would like a bit of advice or even personal recommendation Thanks again

 

[makeitfit]

Are you only running diesel ?

 

[John B]

Yeah :thumbs

 

[Lazy-Ferret]

I got mine from Ebay, and after the second set only lasted 3 months before going hard and leaking all over the place I went to my local Motor factor, and got it from them, and nearly a year on, and it's all fine... so far, touch wood.

 

[John B]

I got the last load from a motor factors but that was also shite

 

[solarman216]

you cannot go wrong with your local motor factors, they are there to serve you and know that if they supply shoddy parts you will be back complaining, also most of your local garages will be dealing with them, ebay you have not got clue what you are really buying, Rick

 

[solarman216]

I got the last load from a motor factors but that was also shite

then take them back, and complain, if you do not then they will not be aware that their supplier has changed its source, Rick

 

[John B]

Does anyone know the inside diameter to save me having to take the old ones off ??

 

[solarman216]

Does anyone know the inside diameter to save me having to take the old ones off ??

I have some left over pipe, will look in the morning, Perkins incidentally used plastic stiff pipe, warm it up in boiling water and push it on never gave any problems for hundreds of K miles, Rick

 

[Bigbunny2007]

I have a few meters at work I think, ill check in the morning if not I can get you some from a supplier next door to me. Check out Beal.co.UK they have all sorts for the automotive industry. I'll post you some at cost of postage :thumb2

 

[John B]

Many thanks just let me know :clap:thumbs

 

[Banshee]

I have a few meters at work I think, ill check in the morning if not I can get you some from a supplier next door to me. Check out Beal.co.UK they have all sorts for the automotive industry. I'll post you some at cost of postage :thumb2

Craigy sort me some out as well, I want some hardcore stuff that'll cope with the Bio :thumb2

 

[solarman216]

ID of rubber pipe is 3.5 mm OD of injector pipe is 4mm not including the lip which of course is bigger, Rick