intercooler

Nissan 4x4 Owners Club Forum

Help Support Nissan 4x4 Owners Club Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Yes and no :p
I'll bring some paper and you can cut and paste to your hearts content :lol
I'll supervise over a tinny :sly

does that mean you will be ready to unleash the pearl by then?:D
 
best stuff for cracked hands is udder cream ;)

http://www.rideaway.co.uk/udder-cre...purenet_feed&gclid=CPiV-dmi6L0CFRCWtAodlzkAjQ

i aint joking either, farmers use it on their hands

Yep udder cream is the stuff :thumb2

I get cracked hands quite a lot from working outside on the farm, used to get it really bad during lambing time as my hands were constantly getting wet and then dried using straw. Best thing is to fill the cracks with udder cream, soon heals them up.

Looking good by the way Steve :)
 
fitted the washer bottle today and got it wired up:D.
not had chance to fit the relay for the fan as I was busy doing a bit more front lift:augie too:D.
tried the fan though and it was sucking not blowing:doh swapped the wires around and sure enough is spun the opposite way but still sucked:doh
so ive got to wip it off and try and reverse the blades:confused:.
hope its doable I don't want spend anymore at mo:(
 

Attachments

  • P1030785.jpg
    P1030785.jpg
    59 KB
change the polarity should make the fan spin the opposite way?
 
I've got the same fan & found once you swapped over the polarity it will blow instead of suck but it's not as strong due to the shape of the fan blades but just checked my fan & there is a 8mm nut in the centre of the fan so it looks as if the fan blades can be flipped over:thumbs
 
did that. still sucked. its down to the blades need reversing
 
I've got the same fan & found once you swapped over the polarity it will blow instead of suck but it's not as strong due to the shape of the fan blades but just checked my fan & there is a 8mm nut in the centre of the fan so it looks as if the fan blades can be flipped over:thumbs

yes I belive the blades need to be reversed:thumb2
 
Once flipped over it'll cool the intercooler nicely:thumb2 got mine off my mate who used it on his pug 306 TD & it managed to keep that engine nice & cool even after all of the engine mods:augie
 
TD IP so you can adjust the fueling to match extra boost ?

explain please:naughty

a mate of mine said it may be possible to turn the fuel pump up:nenau

ultimately I will be getting it remapped but is it worth fitting a maf amp or speed chip,turning pump up first or just remap?
 

Latest posts

Back
Top