Hub Caps

[AD Ent]

Will these fit standard 16" wheels?

X1 http://www.ebay.co.uk/itm/Wheel-Hub...r_Truck_Parts_Accessories&hash=item53f2aabf7a

X4 http://www.ebay.co.uk/itm/4-x-Wheel...r_Truck_Parts_Accessories&hash=item53ef5fbcc5

"Height from surface to foot end: 78mm (3.04inch); inside diameter of foot: 105mm (4.13inch)"

OR

http://www.ebay.co.uk/itm/Chrome-Pl...r_Truck_Parts_Accessories&hash=item3ccd4eea23

"Outside diameter: 130 mm (5") Inside diameter: 107 mm (4" 1/4) Height: 60 mm (2"3/8)"

 

[AD Ent]

bump

 

[Lazy-Ferret]

Not sure what "Standard" 16 inch wheels are... and even then, what are standard in the UK, might not be in the USA

My 1999 T2 has Alloy 16 inch wheels, but I do not have either of the part numbers shown on the ebay listings on my centre hubs.. Mine has 40315 8F300

Approx dimensions:-

Overall maximum outside diameter 126mm
Outside diameter of the locking clips at their peaks 112mm
Diameter of the locking clips to the flat rather than than wedge peak that clips over to hold it in place is 109mm
Overall maximum height of the whole unit to the tip of the clips 65mm

I would have thought, since the wheel has to pass over the location flange on the hubs, that the centre hole size would be standard on any size T2 wheel, and the only difference would be if you have auto or manual hubs on the front, as the cap has either clear over the hub locker or have a cut out for you to get to the hub locker, but his measurements now make me wonder on that.

 

[MudLifeCrisis]

Your motor looks at bit low on the front LF do the torsion bars need a tweek or is it just the weight of those spotlights :lol

Brian

 

[R1cho]

Your motor looks at bit low on the front LF do the torsion bars need a tweek or is it just the weight of those spotlights :lol

Brian

a bit? looks a lot low :lol get the spanners out and get it sorted fella :lol

 

[Lazy-Ferret]

I was looking for a tongue sticking out icon...:lol

I think some of it is the picture, as It is just coming up out of a dip.


How high should it be at the front, I am a bit nervous of playing with the suspension, in case something goes wrong.

 

[MudLifeCrisis]

I was looking for a tongue sticking out icon...:lol

I think some of it is the picture, as It is just coming up out of a dip.


How high should it be at the front, I am a bit nervous of playing with the suspension, in case something goes wrong.

Front should be about half inch lower than the back .