Help!!! clutch release bearing guide tube needed!

[jd013]

Hello all!

New to this and terrano problems....

Took the truck in to have a new clutch fitted after numerous faults. Garage fitting the new clutch say the clutch release bearing guide tube has been damaged due to the old bearing exploding. And they are struggling to get hold of another.
Nissan dealers saying seven weeks or more to get part but not sure about ford. Also ordering the right part!
If anyone has any ideas or even has one for sale that would be much appreciated!
Oh yes! It's a terrano 2 2.7 td. On an x plate.

Many thanks

 

[Banshee]

Hello all!

New to this and terrano problems....

Took the truck in to have a new clutch fitted after numerous faults. Garage fitting the new clutch say the clutch release bearing guide tube has been damaged due to the old bearing exploding. And they are struggling to get hold of another.
Nissan dealers saying seven weeks or more to get part but not sure about ford. Also ordering the right part!
If anyone has any ideas or even has one for sale that would be much appreciated!
Oh yes! It's a terrano 2 2.7 td. On an x plate.

Many thanks

Have a look and see if Milners can hook you up
http://www.milneroffroad.com/nissan/terrano/r20-2-7td-1993-1999-maverick-1993-terrano-1/r20-clutch-1

Can you point out what you need from the diagram here?

 

[jd013]

Hi banshee

Thanks for the quick reply!

Just tried milners and like everywhere else I've tried the part isn't listed.
It's also not on the diagram.
The part is a tube with a flange on one end which bolts inside the bell housing and the release bearing sits on the outside of it. With the shaft in the middle of the tube when assembled.

Thanks for your help!

 

[Madmark]

Hi fella I have spare gear box and engine with clutch at home I can have a look at 5 when I get home send me a text and ill give ya a bell when I get there to look 07769154840

 

[jd013]

Ok cheers!

 

[elty001]

If it the arm you need to hold the release bearing I have one in the shed.

 

[jd013]

Thanks elty the arm is ok. It is the guide tube which the release bearing sits on.

 

[solarman216]

I have what you need, flange that bolts to the gearbox end of the bell housing that the thrust bearing slides on, £20 plus p&p, pm me your addy if you want it, Rick

 

[Banshee]

I have what you need, flange that bolts to the gearbox end of the bell housing that the thrust bearing slides on, £20 plus p&p, pm me your addy if you want it, Rick

What a bloke :bow

All hail Rick the Oracle :question

 

[jd013]

Morning!

Much appreciated solarman but madmark has sorted me with that very part!
Really glad I joined this here site. I was struggling to get hold of this component. And not planning ti get rid of this truck for a long time yet.
It does have loads more issues and faults but i will do one at a time....if possible!

Thanks again

 

[Banshee]

Morning!

Much appreciated solarman but madmark has sorted me with that very part!
Really glad I joined this here site. I was struggling to get hold of this component. And not planning ti get rid of this truck for a long time yet.
It does have loads more issues and faults but i will do one at a time....if possible!

Thanks again

You're more than welcome here mate, going to sounds really gay now but we are like a giant family here :thumb2

We'll get all your issues sorted straight out