flexi hose

[brianbrianyi]

hope you can help i need the flexi hose from clutch slave cylende to the block on the chassie dont no what it is called but it is weaping from the crimped end that goes to the slave cylender the numbers ect on the hose are vicke sae j1401 1/8 " hl 7548a hope this helps regards brian

 

[Terranosaurus]

I've never tried for a T2/Mav but would have thought this should be an over the counter part at any motor factors, might need ordering in but shouldn't be hard for them to get. If you have trouble try yellow pages or yell for hydraulic hose suppliers. You'll need to take the hoe in to someone like that as they'll be used to people ordering based on a spec for industrial applications but they should be able to sort you out.

 

[brianbrianyi]

phoned local motor factor could not help

 

[metalguru]

Hi BB,
I use PIRTEK for all my hoses and so far they have always come up with the goods.
Take your old one in and even if they don`t have the ends they can reuse yours and recrimp.
Prices good too.

 

[brianbrianyi]

Hi BB,
I use PIRTEK for all my hoses and so far they have always come up with the goods.
Take your old one in and even if they don`t have the ends they can reuse yours and recrimp.
Prices good too.

thank u they come to were i work

 

[terranokid]

I have used pirtek as well when i have done one but i did away with the damper pipe i just had a flexi pipe from the master cylinder to the slave.

 

[brianbrianyi]

I have used pirtek as well when i have done one but i did away with the damper pipe i just had a flexi pipe from the master cylinder to the slave.

so did the pipes just couple together

 

[terranokid]

no i just had one pipe made with the correct ends that connected from the master cylinder direct to the slave and it did away with all the rigid pipes and connecting blocks.

It had the same ends as you find on the braking system perhaps the company that shark1e uses to make the brake hoses could help.

 

[Terranosaurus]

Anyone know what size unions are used on our trucks for the brake and clutch flexis and solid pies?

 

[rsaddo]

I have used pirtek as well when i have done one but i did away with the damper pipe i just had a flexi pipe from the master cylinder to the slave.

When you say damper pipe is this the 8mm pipe of the side of the block which heads to the rear of the truck,just changed my slave flexi now this pipe is leaking lost all my fluid lastnight i take its ok to take this pipe outa the clutch system :?: