fault finding

[exosteve]

I'm trying to do the paper clip trick.
But my plug is different from the one shown in the download section
Any one know which two to bridge on the 16 pin plug?

 

[Banshee]

I'm trying to do the paper clip trick.
But my plug is different from the one shown in the download section
Any one know which two to bridge on the 16 pin plug?

If you find this out please post back, Ray is going to be on the ball again soon trying to to get the 14 - 16 pins stuff working again with me :naughty

 

[Sweety]

I can never remember the number of pins on mine:doh but it's the later plug being an 55 plate & you bridge the far bottom left & right pins:thumbs

 

[AlexD333]

If you find this out please post back, Ray is going to be on the ball again soon trying to to get the 14 - 16 pins stuff working again with me :naughty

Banshee I did a pic on this on Facebook forum last night for someone, hold on :thumb2

 

[AlexD333]

Here we are chaps, for the later trucks like ours :thumbs

 

[exosteve]

yes that's right alex.mine is code 34. ive cleaned all connectors. cleaned the injectors. done a service.
I was hoping to cancel the eml code but I couldn't figure that bit out.
I tried like it says in the download with no joy.
I want to cancel it to see iff my 2 out of three fixes has solved the problem.
if it comes on again it must be the sensor

 

[AlexD333]

Yeah you need to tap one side of the paper lip in and out of the connector quickly, it's quite fiddily...

Once that's done keep ignition on and wait for code 55, this means you have cleared it :thumb2