Excellent Service (key fob)

[Big Col]

Just in case anyone is interested I used this company http://www.keyfobrepair.co.uk/index.html because I had a knackered key fob ( remote) . I posted it Thursday afternoon registered post £2 they got it this morning. They at lunchtime today said it was all done with new case and the board repaired for..... £25 + postage which I thought was pretty good. Colin

 

[(RIP) PLANK]

sounds pretty good :thumb2

 

[AD Ent]

Ive only got 1 key.

 

[rustic]

Re synchronising the key fob.
Found from their site for Terrano II

Ensure all the doors have been unlocked, either by using a good transponder key or remote control plip key.
Procedure
1. Turn the ignition switch from Position 0 to ON 6 times within 10 seconds.
2. Then turn ignition switch to OFF position. Leave key in ignition switch.
3. After 2 seconds, the system will enter programming mode and will flash the warning lights twice.
4. Press and HOLD the unlock button on the Plip.
5. While pressing the unlock button, press the lock button 3 times.
6. Release the unlock button.
7. The warning lights will flash once to indicate successful programming.
8. Repeat procedure 4 to 7 for up to 4 plip key’s.
9. When completed turn ignition ON, and the warning lights will flash 2 times.
10. Remove key, and check all plip key’s for operation.
NOTE : The programming mode will stop when either the ignition is switch ON, 4 plip keys have been programmed or no input signal either from the switch or plip keys has been received for 120 seconds.


Thought it might help.

Rustic

 

[exosteve]

Re synchronising the key fob.
Found from their site for Terrano II

Ensure all the doors have been unlocked, either by using a good transponder key or remote control plip key.
Procedure
1. Turn the ignition switch from Position 0 to ON 6 times within 10 seconds.
2. Then turn ignition switch to OFF position. Leave key in ignition switch.
3. After 2 seconds, the system will enter programming mode and will flash the warning lights twice.
4. Press and HOLD the unlock button on the Plip.
5. While pressing the unlock button, press the lock button 3 times.
6. Release the unlock button.
7. The warning lights will flash once to indicate successful programming.
8. Repeat procedure 4 to 7 for up to 4 plip key’s.
9. When completed turn ignition ON, and the warning lights will flash 2 times.
10. Remove key, and check all plip key’s for operation.
NOTE : The programming mode will stop when either the ignition is switch ON, 4 plip keys have been programmed or no input signal either from the switch or plip keys has been received for 120 seconds.


Thought it might help.

Rustic

that's a good bit of info, cheersmate.
my key will unlock it but not lock it I have to do it manualy with the key in the door

 

[Thomas-the-Terrano2]

good link, mine needs doing, just never seem to get round to it.

seen few firms on ebay, been all set to send it to a guy in peterborough
thats very reasonable too.