Car won't start only crank over

[marcusberry26]

Went out in terrano 2 2.7tdi yesterday all fine. Turned it off and then tried to start a few minutes later and just cranked over and over. Can't get ml indicator to flash a fault code. Any ideas?

 

[clivvy]

could be good old CKP sensor-check the plug at the front where all the plugs and connectors are-the ckp runs form between the belts, up over the thermostat area to the plugs...also check yoru fuel filter-prime it if its loose then try starting again.

could also be your starter not engaging...!

 

[marcusberry26]

Cup

There are no wires at the front. Could the ckp be at the back instead? Thanks

 

[mjpetersen]

Sometimes the NATS gets confused I think, but I have had success simply by pulling the key, holding it away from the switch for a few seconds, and then trying again. Maybe that will do it.

Mike

 

[clivvy]

ckp - depends on year of your car, could well be at the back in the bell housing..

 

[DEE]

Oi

Sometimes the NATS gets confused I think, but I have had success simply by pulling the key, holding it away from the switch for a few seconds, and then trying again. Maybe that will do it.

Mike

I am with this one Had the same thing on a truck The chip fell out of the key

 

[cncfabs]

There are no wires at the front. Could the ckp be at the back instead? Thanks

Will be on top of belhousing if its bosch system see that maf you have to determine which type