I have a problem with my front passenger wheel it it angled In at the top. Have taken it to two local garages and neither can see anything obvious? :nenau
Check your balls first mate and after that you check the bush
Wheel bearings next.
IF all that lot's fine then you could check camber with the shim washers, but unusual :augie
Only passenger side and gradually getting worse buy noticed more when it had totally scrubed the inner edge off my mud tyres. To check ball joints I just jackes it up and pulled and tugged lol. Also garage had it on shaker plates.
Not too bad if the fookin' nuts come off. They're huge and probably been there since built.
Check them by dropping the top ball joint and give the arm a wiggle.