body lift

Nissan 4x4 Owners Club Forum

Help Support Nissan 4x4 Owners Club Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

96terrano

Well-known member
Joined
Jun 27, 2010
Messages
8,022
well, i might as well do one if just to get to the chassis for under sealing, whats the highest i can go without buggering/changing stuff? eg transfer leaver also, universal kits seem cheaper, anybody got recommendations
 
well, i might as well do one if just to get to the chassis for under sealing, whats the highest i can go without buggering/changing stuff? eg transfer leaver also, universal kits seem cheaper, anybody got recommendations

biggest without modding transfer lever is 2" but even then sometimes you have to trim the center console to get it into 4low
 
biggest without modding transfer lever is 2" but even then sometimes you have to trim the center console to get it into 4low

what i might do with that is make new brackets and move the center console back slightly
 
ok, serious

i'm wanting to deffinatly buy a body lift, a guy on Facebook quoted mt £60 for one, i want to know, is their any cheaper?
 
console will have to go back to get into 4low, bumpers will need adjusting and rad cowling will have to come off,
 
console will have to go back to get into 4low, bumpers will need adjusting and rad cowling will have to come off,

going to go 2" as the maker said i could go and i quote '2" with out lever mod', also will get get some of those spring lifter thingamabobs:thumb2
 
going to go 2" as the maker said i could go and i quote '2" with out lever mod', also will get get some of those spring lifter thingamabobs:thumb2

this is in the Hyundai project car ? :augie
 
Ballox, 2" lift WILL need a slight trim round the ratio lever slot.
 
So 40mm then? Who do I believe, a 'nissan' owners club or a guy who has mostly done troopers:lol
 
So 40mm then? Who do I believe, a 'nissan' owners club or a guy who has mostly done troopers:lol

40mm will be fine but will still have to alter the bumpers and remove the rad cowling
 
But I don't want to sabotage my transfer leaver or console. Hmfff
 
Then you can take your lever to the blacksmith and get him to heat it up and bend the bugger a bit.
 

Latest posts

Back
Top