Bad steering play

Nissan 4x4 Owners Club Forum

Help Support Nissan 4x4 Owners Club Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Do not worry about it it will not fall off, just get the plastic bushes and we will fit them on Sat, Rick

Aha awesome. I have had a wobble at the front for quite some time, always put it down to bad balancing but actually it's quite clear it's this now.

In which case it's been wearing for eons :lol

Anyone know where I can get one? Or a bush?

Poly? :naughty
 
You can get it if you like, but got to be lots dearer than a couple of plastic bushes, and you will not be fitting it without a ball joint splitter and the three bolts might just shear off, your choice, as I said so you have a little play but will not interfere with your laning, and will not drop off, Rick
 
You can get it if you like, but got to be lots dearer than a couple of plastic bushes, and you will not be fitting it without a ball joint splitter and the three bolts might just shear off, your choice, as I said so you have a little play but will not interfere with your laning, and will not drop off, Rick

Wicked, I will leave it alone until then. Thanks of putting my mind at rest :thumbs

I will bring along polish and truck wash too!! Make sure your missus' car is around :cool:
 
Wicked, I will leave it alone until then. Thanks of putting my mind at rest :thumbs

I will bring along polish and truck wash too!! Make sure your missus' car is around :cool:

I will put wheel clamps on it, Rick
 
As an eBay Associate we earn from qualifying purchases.
Well it could be, but remember yours is a 2004, think when they say 93 on it means up to 99, so not sure, your best bet is to go to Nissan and see if they are different or Milners for pattern parts, Rick

Cool hokie cokie :thumb2

I will do a bit of research and see what I can dig up. I have Time to play with so all good :cool:
 
I have got one you can have as a spare or get some bushes in it then swap it to your truck.
The ones from milners don't fit very well and you have to open one of the holes up to get them to line up with the holes on the chassis.
 

Latest posts

Back
Top