ABS Sensor required

Nissan 4x4 Owners Club Forum

Help Support Nissan 4x4 Owners Club Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

davemud

Well-known member
Joined
Jun 23, 2005
Messages
403
HI u Guys

I need to get hold of an ABS sensor for the front any after market options
or Nissan Only

thanks Suggestion welcome

Davemud
 
Hi Dave, bad news I'm afraid mate they are dealer part only £214. Scrappers will only sell you the complete hub thing with the sensor. The sensors rust in and are a bugger to get out, certainly can't without breaking them. If your's has gone like mine it is the wires that have broken. It's usually the NSF, don't know why. Mine had been repaired before and not sealed so the water had bled through the wire corroding the lot, I managed to hack saw part of the case off to find good wire to solder. If you trace the wires from the sensor it clamps to the suspension arm and has thicker insulation just there and that is where it normally breaks. If your lucky you will be able to rejoin the wires there, if not trace the wires back until you get clean copper to solder and replace all the way up to the plug in the engine bay. Once you have repaired it make sure the cables are well sealed from the water.

Let me know if you need any more advice.

Jim
 
HI ya Jim

Had to remove the sensor to get the drive flange off oils seal damaged
and leaking water in contaminating the grease
yep the thing was stuck fast, but only light bit of pressure and
some wd40 no sign of damage but code reader says
that the side that faulty. :(

Oh well have to save up to get that on order then

davemud
 
If it's not actually damaged it may still be a broken wire, your going to lose nowt by checking the wires by the sounds of it. Also just noticed that yours is a trol but I reckon the principle will be the same.

Jim T
 

Latest posts

Back
Top