Search results

Thanks for feedback guys I have done a temporary bodge which seems OK for now with the weak joint I partly filled it with hot glue, then heated it up with the shrink gun until it was soft again, heated the male and pressed them together after floating a pool of silicon grease on top of the soft...

too hard to drill I saw a youtube video recently about clips to hold them on, cant seem to find it again, any ideas ?

Thanks Rick, I am going to attempt to drill it later will use dremmel type tool with small stone to cut through the assumed case hardening coat, then try to drill and tap I will update later

Phew OK so far so good, I have the arm out of the car with the blade fitting, hardest bit was getting the blade off the tapered spline, 25 year old screws all came out, impact wrench helped loads The arm had fallen off the centre fitting Popped the arm off the blade fitting[dunno what to call...

Thanks Seems too easy, I should make good progress now, or have I stirred Murphy:doh:doh

HELP I can't figure out the fixing holding down the plastic cover over the wiper mech, looks like it is either hex [Alen] or torque but none of my keys will fit, I am well stuck. There are 3 of them in recesses, at last resort I will drill the heads off is extractors will not work, BUT guidance...

Thanks guys, I will post an update

the N/S works OK I think it is the mechanism under the plastic below the windshield Does anyone have a manual. I used to look at the online one but that seems to have gone walkabout Anyone had this happen I have felt the end of the arm, there is no sign of movement so I guess the stuff under...

Had a Kenlow, in the late 80's when it snowed down here and went down to -10C, thanks to global warming not that cold any more Did the job well and the motor did seize, remember to run it for a few seconds every week, pain in the butt freeing it

Use a bit of tube over the drill so it stops the drill going too far, stop if falling off with a bit of masking tape, around the top of the tube then onto the chuck or squash it with pliers, you can actually buy depth stops but I found a bit of tube and tape were easy and cheap

I have bought a bike to do up so need space in workshop The seats were taken out many years ago and were in good condition I use the Mav as a van Anyone want them before I take them to tip Collection only unless you live close anyone interested I can post pics if that is still possible without a...

Thank you good idea I hope you can work it

pdf name Hi, I should have the pdf on my old hard drive, what was it called for my 98 2.7 non electricery model? please

help with manuals Hi, is there a way to download manuals, while you have been away they have gone walkabout :lol

Found it I thought that bit was part of the bell housing I am more familiar with cars so I guess that explains it

Thank you I must have spent about an hour scrabbling about underneath, could not find it again :doh, I had found it OK when I changed the oil, a long while ago, but for the life of me I was stumped this time round, I think oldtimers has go a lot to answer for Thanks again, I will check it out...

help with manuals Hi Guys, Back again, was the problem ever fixed I want to top up my gearbox and cant find the fill hole HELP:eek:

AA dont cover the vehicle, they cover the member, they did not ask for a reg, any vehicle I am with is covered, mind you I have NOT read the small print

ryobi do one 400 newtons seen in b&q around £100

I know nothing about this stuff but have you tried a boat anchor in soft ground, it will bury itself