gear box not changing properly, What ATF plz?

27-11-2009, 01:47

Just bought a terrano II 95M and when driving it it seemed to be not changing gear right although it does change gear? If hold full throttle on it dont change gear until revs are released. So if driving up hill and put under load it does not back down a gear when reving but stays in same gear as approching. It will go through all gears but have to back off on the gas each time to get a gear change?

Deleted account DD · 27-11-2009, 09:26

So the summary is revs to idle when changing gear?

Any graunching noises at all?

tezzer · 27-11-2009, 09:35

could it be the kickdown cable needs adjusting, as it seems to be hold gears??
just a thought.

bobbee · 27-11-2009, 14:04

i got the same prob. how do you adjust kick down cable

zippy656 · 27-11-2009, 14:18

talk a look in the manual, you might be able to see then

supertaff · 27-11-2009, 14:58

Daft question ... it's not a case of the switch on the dash being in "Hold" or "Economy" position , is it?

04-12-2009, 21:18

Quote:

Originally Posted by cjustice

Just bought a terrano II 95M and when driving it it seemed to be not changing gear right although it does change gear? If hold full throttle on it dont change gear until revs are released. So if driving up hill and put under load it does not back down a gear when reving but stays in same gear as approching. It will go through all gears but have to back off on the gas each time to get a gear change?

I found the problem!! sneaky filter in the banjo limiting the fuel and so engine had no beans!! sneaky sneaky sneaky, what a place to put a second fuel filter!

04-12-2009, 21:19

many thanks for help

zippy656 · 04-12-2009, 21:55

did you do it the easy way or the hard way??

tezzer · 05-12-2009, 01:23

whats the easy way zipps, i thought it was a bitch of a job,?

27-11-2009, 01:47	#1
cjustice Guest Posts: n/a	gear box not changing properly, What ATF plz? Just bought a terrano II 95M and when driving it it seemed to be not changing gear right although it does change gear? If hold full throttle on it dont change gear until revs are released. So if driving up hill and put under load it does not back down a gear when reving but stays in same gear as approching. It will go through all gears but have to back off on the gas each time to get a gear change?

27-11-2009, 09:26	#2
Deleted account DD Senior Member Join Date: Sep 2008 Posts: 4,705	So the summary is revs to idle when changing gear? Any graunching noises at all?

27-11-2009, 09:35	#3
tezzer Senior Member Join Date: Nov 2008 Location: basildon essex Vehicle: transit camper van 1987 Posts: 2,829	could it be the kickdown cable needs adjusting, as it seems to be hold gears?? just a thought.

27-11-2009, 14:04	#4
bobbee Senior Member Join Date: Nov 2009 Location: s.east (kent) Vehicle: mistral 2.7td 1995 Posts: 121	i got the same prob. how do you adjust kick down cable

27-11-2009, 14:18	#5
zippy656 Senior Member Join Date: Aug 2008 Location: Devizes Wiltshire Vehicle: Nissan Note Ntec 1.5 Posts: 14,138	talk a look in the manual, you might be able to see then

27-11-2009, 14:58	#6
supertaff Senior Member Join Date: Jun 2007 Location: Swansea, South Wales Vehicle: 1999 (V) Terrano II SE Posts: 273	Daft question ... it's not a case of the switch on the dash being in "Hold" or "Economy" position , is it?

04-12-2009, 21:19	#8
cjustice Guest Posts: n/a	many thanks for help

04-12-2009, 21:55	#9
zippy656 Senior Member Join Date: Aug 2008 Location: Devizes Wiltshire Vehicle: Nissan Note Ntec 1.5 Posts: 14,138	did you do it the easy way or the hard way??

05-12-2009, 01:23	#10
tezzer Senior Member Join Date: Nov 2008 Location: basildon essex Vehicle: transit camper van 1987 Posts: 2,829	whats the easy way zipps, i thought it was a bitch of a job,?