Wheel bearing part numbers

[Davey Boy]

Once upon a time.....
I had the inner front wheel bearing numbers for the y61 Patrol, but can't find them now.

Got the small outer bearing race & cone LM501349/LM501310 but it's the larger inner tapered bearing parts I need.
Without getting the old one off for the numbers I can't order a new inner taper bearing.
Actual bearing numbers needed, not Nissan part numbers.

Thanks for your help.
D

[russell.huffer]

Got mine from Milners came in Nissan packets but fraction of the cost, be aware you need the proper pin tool to retighten these up, as my first set failed because I could not tighten them enough to seat them down, second set done with tool perfect.

Kind regards


Russell.

[Davey Boy]

Thanks Russ
I get my bearings from a specialist bearing supplier.
Must see if I can find the receipt.
I use Timken if I can.
I used Milners years ago for a set of bearings and seals. All the seals were wrong, and the bearings at the time were just a bit too shy on quality for me.
I’ve got the hang of pre-loading the bearings, but it would be nice to use a proper pin tool.
Where did you get yours from?
Over here or Oz?
Best
D

[russell.huffer]

I bought mine from Oz via Ebay, has 1/2 inch drive fitment great tool.

Kind regards

Russell.

[Davey Boy]

Thanks Buddy.
I have seen them.
I’m gonna get one.
D

[Wheelie]

Originally Posted by Davey Boy

Once upon a time.....
I had the inner front wheel bearing numbers for the y61 Patrol, but can't find them now.

Got the small outer bearing race & cone LM501349/LM501310 but it's the larger inner tapered bearing parts I need.
Without getting the old one off for the numbers I can't order a new inner taper bearing.
Actual bearing numbers needed, not Nissan part numbers.

Thanks for your help.
D

I have a front wheel bearing in my draw, ill go out and check it for you

[Wheelie]

Does this sound right
4T 33110x2
4T 33110

[Davey Boy]

Neil, that rings a bell with a receipt I’ve seen.
Good work & thanks!
D