Go Back   :::.Nissan 4x4 Owners Club.::: > General > The Clubs Virtual Pub

The Clubs Virtual Pub For general chat, so come on in and pull up a chair.

Reply
 
Thread Tools Display Modes
Old 08-01-2015, 22:58   #1
solarman216
Off road maniac
Click here to find out how to become a paid up member
 
solarman216's Avatar
 
Join Date: Dec 2009
Location: Bexhill on Sea
Vehicle: Y60 Patrol Me, 3 ltr Mrs
Posts: 17,431
Default 1.5 inches of rain

Hi all had a very hard day today, last night and early this am we recorded 1.5 inches of rain, which has caused a lot of not so much damage but hassle, I have video but cannot put it up as running out of monthly gb, but for those of you that know my yard, (lots) let me say that it was streaming over my gate and the one foot board that runs along the bottom (10 ft wide) and then down the track running around 4 inches deep, it has done a wonderful job of washing all the mud a silt which comes down on a normal basis and now have bright exposed hard core and spotted tarmac, down side is my workshop was flooded to about 2 ft, covered my mig that was on the floor completely, remains to be seen if it is recoverable, it is not the water that is the problem but the silt that comes with it, when the water drained at about 2 pm I was left with one to 2 inches of silt on the workshop floor fortunately I had the help of two friends who worked tirelessly till 5 pm helping me clear it, the barn was also flooded but only to around 4 inches but it still has a layer of silt and as this is 45 ft by 25 ft and full mainly of stuff on the floor, it will take a lot longer to sort, the cause of all this is two fold, first the culvert under the farmers road has collapsed resulting in the stream flowing over his road and toward my gate which I had taken the precaution of fitting a 1ft board along the bottom to redirect the water back into the stream but today's deluge defeated that and it came over the top, second I have discovered a pinch point on the stream that would have redirected the water toward my workshop and barn any way, so I have some work to do to make sure this does not happen again, good news is the house was 4 foot above it all, I have had a wine or two and am now going to have a scotch or two or three as knackered, Rick
__________________
Ex banger racer now off road maniac
Lokka on the front with manual hubs
Diff lock on rear
3 inch SS straight through exhaust
Manly winch bumper with 13000 lb winch
10 spike ground anchor, with multiple straps and blocks
Super strong body cills capped with scaffold pole
20% stronger springs all round
aggressive off road tyres on wheels so just swap.
Aim to get stuck and be completely self sufficient in extraction, love getting muddy, 2ft deep is good but rare.
solarman216 is offline   Reply With Quote
Old 08-01-2015, 23:03   #2
briggie
Senior Member
Click here to find out how to become a paid up member
 
Join Date: Mar 2010
Location: peoples democratic republic of west yorkshire
Vehicle: " alice "
Posts: 10,473
Default

hells bells mate , hope you are all ok , needless to say if i can help in anyway , don't hesitate to message / ring me .
briggie is offline   Reply With Quote
Old 08-01-2015, 23:04   #3
Lazy-Ferret
Senior Member
Click here to find out how to become a paid up member
 
Join Date: Jun 2012
Location: Sevenoaks, Kent
Vehicle: Terrano 2.7TDi SE Touring
Posts: 5,221
Default

Ohhh, that's terrible Rick, if we can give you a hand any day, give us a shout, and as long as we are not booked up, we will willingly come down and help you move/lift/clean stuff up.

We only had 3/4 of an Inch here, but we are higher up, so a lot less hassle for us.
Lazy-Ferret is offline   Reply With Quote
Old 08-01-2015, 23:27   #4
perelaar
Senior Member
Click here to find out how to become a paid up member
 
Join Date: Sep 2014
Location: Belgium
Vehicle: Terrano II 2.7TDi SWB '97
Posts: 802
Default

Ouch, not nice to hear that! Helped clean the silt out of aunt's house a few years ago, so I have an idea on what you are dealing with.

I hope you can find a way to tackle the cause of the flooding...
perelaar is offline   Reply With Quote
Old 08-01-2015, 23:27   #5
solarman216
Off road maniac
Click here to find out how to become a paid up member
 
solarman216's Avatar
 
Join Date: Dec 2009
Location: Bexhill on Sea
Vehicle: Y60 Patrol Me, 3 ltr Mrs
Posts: 17,431
Default

Thanks Clive and Pete, but we are fine, just have to take what life throws at you, silly as it sounds but I am really upset about my digital DC clamp meter that had been underwater for hours, it is most unlikely to recover and to find another as good at a reasonable price will be hard, angle grinder, jig saw, volt meter, cheap endoscope etc not so bothered about, regards Rick
__________________
Ex banger racer now off road maniac
Lokka on the front with manual hubs
Diff lock on rear
3 inch SS straight through exhaust
Manly winch bumper with 13000 lb winch
10 spike ground anchor, with multiple straps and blocks
Super strong body cills capped with scaffold pole
20% stronger springs all round
aggressive off road tyres on wheels so just swap.
Aim to get stuck and be completely self sufficient in extraction, love getting muddy, 2ft deep is good but rare.
solarman216 is offline   Reply With Quote
Old 08-01-2015, 23:58   #6
AlexD333
Senior Member
Click here to find out how to become a paid up member
 
Join Date: Jan 2014
Location: Uk
Vehicle: 2004 Terrano 2.7 TDI
Posts: 7,847
Default

Yep, if you need help message I will find a way of getting down!

House is safe you say, that's good news
AlexD333 is offline   Reply With Quote
Old 09-01-2015, 00:00   #7
AlexD333
Senior Member
Click here to find out how to become a paid up member
 
Join Date: Jan 2014
Location: Uk
Vehicle: 2004 Terrano 2.7 TDI
Posts: 7,847
Default

These meters?

https://www.google.co.uk/?gws_rd=ssl...meter&tbm=shop
AlexD333 is offline   Reply With Quote
Old 09-01-2015, 00:32   #8
rayf3262
Senior Member
Click here to find out how to become a paid up member
 
rayf3262's Avatar
 
Join Date: Nov 2009
Location: Norfolk, Poringland NR14
Vehicle: Terrano 3.0 SVE 2002
Posts: 1,549
Default

Quote:
Originally Posted by solarman216 View Post
silly as it sounds but I am really upset about my digital DC clamp meter that had been underwater for hours, it is most unlikely to recover and to find another as good at a reasonable price will be hard, s Rick
Rick, take the battery out and give it a bath in clean warm water.
Then take it apart as best you can and warm air dry it.
__________________
Remember what the dormouse said:
Feed your head....
rayf3262 is offline   Reply With Quote
Old 09-01-2015, 00:37   #9
solarman216
Off road maniac
Click here to find out how to become a paid up member
 
solarman216's Avatar
 
Join Date: Dec 2009
Location: Bexhill on Sea
Vehicle: Y60 Patrol Me, 3 ltr Mrs
Posts: 17,431
Default

Quote:
Originally Posted by AlexD333 View Post
thank's Alex but none come close, my one did two ranges DC 200 amps good for charging circuits, and 1200 amps good for starters, 1000 amps is not enough as the start surge will push it out of range, rick
__________________
Ex banger racer now off road maniac
Lokka on the front with manual hubs
Diff lock on rear
3 inch SS straight through exhaust
Manly winch bumper with 13000 lb winch
10 spike ground anchor, with multiple straps and blocks
Super strong body cills capped with scaffold pole
20% stronger springs all round
aggressive off road tyres on wheels so just swap.
Aim to get stuck and be completely self sufficient in extraction, love getting muddy, 2ft deep is good but rare.
solarman216 is offline   Reply With Quote
Old 09-01-2015, 00:39   #10
solarman216
Off road maniac
Click here to find out how to become a paid up member
 
solarman216's Avatar
 
Join Date: Dec 2009
Location: Bexhill on Sea
Vehicle: Y60 Patrol Me, 3 ltr Mrs
Posts: 17,431
Default

Quote:
Originally Posted by rayf3262 View Post
Rick, take the battery out and give it a bath in clean warm water.
Then take it apart as best you can and warm air dry it.
exactly what I have done, thanks ray for backing up what I thought, Rick
__________________
Ex banger racer now off road maniac
Lokka on the front with manual hubs
Diff lock on rear
3 inch SS straight through exhaust
Manly winch bumper with 13000 lb winch
10 spike ground anchor, with multiple straps and blocks
Super strong body cills capped with scaffold pole
20% stronger springs all round
aggressive off road tyres on wheels so just swap.
Aim to get stuck and be completely self sufficient in extraction, love getting muddy, 2ft deep is good but rare.
solarman216 is offline   Reply With Quote
Old 09-01-2015, 00:44   #11
rayf3262
Senior Member
Click here to find out how to become a paid up member
 
rayf3262's Avatar
 
Join Date: Nov 2009
Location: Norfolk, Poringland NR14
Vehicle: Terrano 3.0 SVE 2002
Posts: 1,549
Default

Quote:
Originally Posted by solarman216 View Post
exactly what I have done, thanks ray for backing up what I thought, Rick
fingers crossed.....
__________________
Remember what the dormouse said:
Feed your head....
rayf3262 is offline   Reply With Quote
Old 09-01-2015, 00:57   #12
solarman216
Off road maniac
Click here to find out how to become a paid up member
 
solarman216's Avatar
 
Join Date: Dec 2009
Location: Bexhill on Sea
Vehicle: Y60 Patrol Me, 3 ltr Mrs
Posts: 17,431
Default

Quote:
Originally Posted by rayf3262 View Post
fingers crossed.....
yep will let you know, same applies to disc cutter, jig saw and brand new impact drill/gun, and maybe mig welder that actually looks quite clean but I saw it up to the top in water but maybe not mud contaminated, time will tell, Rick
__________________
Ex banger racer now off road maniac
Lokka on the front with manual hubs
Diff lock on rear
3 inch SS straight through exhaust
Manly winch bumper with 13000 lb winch
10 spike ground anchor, with multiple straps and blocks
Super strong body cills capped with scaffold pole
20% stronger springs all round
aggressive off road tyres on wheels so just swap.
Aim to get stuck and be completely self sufficient in extraction, love getting muddy, 2ft deep is good but rare.
solarman216 is offline   Reply With Quote
Old 09-01-2015, 07:21   #13
AlexD333
Senior Member
Click here to find out how to become a paid up member
 
Join Date: Jan 2014
Location: Uk
Vehicle: 2004 Terrano 2.7 TDI
Posts: 7,847
Default

Quote:
Originally Posted by solarman216 View Post
yep will let you know, same applies to disc cutter, jig saw and brand new impact drill/gun, and maybe mig welder that actually looks quite clean but I saw it up to the top in water but maybe not mud contaminated, time will tell, Rick
Bloody ell mate, you've been really unlucky with this

Hope it all works out. As mentioned if you need help do call!
AlexD333 is offline   Reply With Quote
Old 09-01-2015, 07:56   #14
briggie
Senior Member
Click here to find out how to become a paid up member
 
Join Date: Mar 2010
Location: peoples democratic republic of west yorkshire
Vehicle: " alice "
Posts: 10,473
Default

Quote:
Originally Posted by AlexD333 View Post
Bloody ell mate, you've been really unlucky with this

Hope it all works out. As mentioned if you need help do call!
pop down anyway alex
briggie is offline   Reply With Quote
Old 09-01-2015, 08:03   #15
bry
Senior Member
Click here to find out how to become a paid up member
 
Join Date: May 2013
Location: South Yorkshire..
Vehicle: Nissan Terrano MK 2 SE
Posts: 1,757
Default

Sorry to hear of your plight.Had i been closer i would been able to help.
bry is offline   Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT +1. The time now is 23:05.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Images online photo albums