Welding airbox ?

[stinka]

It's thin !

Do u recon my snap-on/cebora 130 mig would, at 30amps low setting, weld it without blowing holes ?

 

[geoffdown]

It's thin !

Do u recon my snap-on/cebora 130 mig would, at 30amps low setting, weld it without blowing holes ?

i welded mine at 25amps and it can be done just dont hang around in 1 place to long and keep stop starting to allow the metal to cool abit before u go again:thumbs

 

[larson]

some times at work i put ally behind the external corners if i blow a hole and cant be arsed setting the welder for 1 little weld then putting it back to were it is now. we have 3 meter lengths of 15.. x 10mm and i put this in to the corner behind were i am welding so i dont get too much penetration.

try it, it pulls away as mild steel is not going to weld to it..

 

[makeitfit]

Just plate it and rivet in place and seal with tigerseal or similar. Piece of piss

 

[geoffdown]

Just plate it and rivet in place and seal with tigerseal or similar. Piece of piss

but he has his new welder (toy) to use:lol

 

[stinka]

but he has his new welder (toy) to use:lol

Exactly

 

[makeitfit]

Good point , then weld up a nice winch bumper :naughty

 

[stinka]

Good point , then weld up a nice winch bumper :naughty

It's just getting materials at the right price

 

[makeitfit]

Materials are cheap enough. You can make it with off cuts too, nothing needs to be that big really :thumb2 Nip down your local smithy :lol