washer sprayers ???

[glen]

My washer spayers ? are not working i have unblocked but still poor how do you take the black sprayer out with the two holes out,so i can clean or replace do not want to force any advice would be good,i have put pin down from bonnet but still not working and blown up the pipe no luck.the hole could be too big now

Glen

 

[supertaff]

Glen, are you sure that no water has frozen in the pipes, or anywhere in the system ? With all this cold weather there could be a blockage due to ICE.

 

[glen]

washers

Put fresh water in used vac to empty,cleaned pipes & sprays but still not working,will check again but think i might need a pair of new sprays or second hand or if i can strip will clean could have more crap in than i think, putting pin down hole should not break them.

Glen

 

[jims-terrano]

Hi Glen, I'd wait and see if they defrost first to be honest with you. I used some Air Duster (pressurised air in an aerosol) and sprayed back through the jets to blow muck out the way it came. My washer bottle developed a load of scale muck on the sides that came loose after a frost and kept blocking my jets. Ended up sticking a hose in my washer bottle for 1/4 hour to wash it out. Then ran clean water through the system without the jets connected. To release the jets from the bonnet I used a pair of long nosed pliers to squeeze the two clips.

Jim T

 

[(RIP) PLANK]

i had so much trouble with the jest blocking in one van i had, i ended up putting a small motorbike fuel filter in line, there was a half a second delay as the pump filled it before it sprayed but I never had a problem again!

 

[glen]

Jets blocked

All
Done jets kept blocking after big clean, the water bottle was black.

Glen