Wanted: Starter motor bolt!

[don simon]

As header, the replacement bolt has come out and obviously need a new one. New one required.

 

[Davey Boy]

Just the one Simon?:nenau

 

[don simon]

Just the one Simon?:nenau

Just the one!

 

[solarman216]

Will look in workshop tomorrow, Zac did you tighten it up nice and tight, if so then could be the thread in the bell housing is getting slack, Rick

 

[Banshee]

That was as tight as you like!!!!! I suspect the threads are no good :O

 

[don simon]

That was as tight as you like!!!!! I suspect the threads are no good :O

Cheers Rick. And I'm not in the mood for goosed threads in bellhousings today...
I could be in the market for a Bosch fuel pump too.

 

[solarman216]

Cheers Rick. And I'm not in the mood for goosed threads in bellhousings today...
I could be in the market for a Bosch fuel pump too.

What is the mater with your pump? Rick

 

[don simon]

What is the mater with your pump? Rick

Suspected leak. I need to give it a bit of a clean and good look, but it'd be nice to know if one's available.

 

[Banshee]

Suspected leak. I need to give it a bit of a clean and good look, but it'd be nice to know if one's available.

I've used mine

 

[solarman216]

Got a couple of bolts, PM me your addy and I will send them off, Rick

 

[don simon]

Got a couple of bolts, PM me your addy and I will send them off, Rick

Received and installed, thanks Rick. :thumbs
What a pig of a job, Now that I've worked a way of supporting the starter motor (wood wedged underneath at the front), locating and cartching the thread becomes a lot easier. We're up and running again.
Obviously I'll keep an eye on it, it is a tight as I could get with a spanner.

:clap

 

[terranosaurusdoug]

Awkward job innit mate

 

[Banshee]

I deffo spannered those in hard!!!!!!

I reckon you've got thread wear so keep an eye on it mate