The dreaded clutch

[R1cho]

well i got a new truck off a member on here, it had the droopy clutch peddle, easy fix it was that stupid pipe that has no use, so blanked it off and bled as needed, clutch peddle sitting at proper height now however i can not get it into gear when the engine is running, goes into gear when turned off but not when running, am i going to need a new clutch? or could it just be stuck being as the truck has been sat for a year?

 

[solarman216]

quite likely stuck, unless you did not bleed it properly, get somebody to look at the slave cylinder while you press the pedal, if OK try pressing pedal to the floor and holding there, select 4th with the HB firmly on and operate the starter, if this does not work jam the pedal down over night and try again, by the way do have any brake rings for hubs, Rick

 

[R1cho]

cheers rick, yes i do, do you want the snap rings and washers too?

 

[Thomas-the-Terrano2]

hi did the heater motor stat thing melt in the fire?

 

[96terrano]

This sounds stupid but it worked for me with a KIA pride if it's a stuck clutch, put in 1st gear and give it a quick crank on the starter, them put it in reverse and do the same. The jerking un stuck it:clap

 

[solarman216]

cheers rick, yes i do, do you want the snap rings and washers too?

ooh yes please, Rick

 

[96terrano]

hi did the heater motor stat thing melt in the fire?

Resistor you're after?