AlexD333
Well-known member
- Joined
- Jan 1, 2014
- Messages
- 7,847
As requested here are some pics of the route I chose to hide the power cable of the camera.
So the wire just tucks in above the trim where the window meets
I used this for the pillar, not to remove it, just to flex it a little and hide the cable behind
Down to the bottom of the windscreen and then I used a big flathead to pry the black panel away from the cream just enough to poke the cable between
Then tucked it all along here
The screw I'm pointing at needs to be removed, you can then pull the panel out (3 L shaped clips)
And the closest I could get without stripping out the dash was here
Took about 15 minutes, I cable tied the excess above the pedals by the fuse box and diagnostic port ect.
Not professional but good enough for me :thumb2
So the wire just tucks in above the trim where the window meets
I used this for the pillar, not to remove it, just to flex it a little and hide the cable behind
Down to the bottom of the windscreen and then I used a big flathead to pry the black panel away from the cream just enough to poke the cable between
Then tucked it all along here
The screw I'm pointing at needs to be removed, you can then pull the panel out (3 L shaped clips)
And the closest I could get without stripping out the dash was here
Took about 15 minutes, I cable tied the excess above the pedals by the fuse box and diagnostic port ect.
Not professional but good enough for me :thumb2
