ride height adjustment

[geoffdown]

hi guys did the torsion bars a day ago the measurment at the bottom wishbone was a diff of 9mm on each side now the manual says it should be 31mm so i adjusted it and measure it a day later and i am getting 40mm diff (when i did it it was measuring around 30mm):doh i now have a measurement at the wheel arch to the hub on the front 1/2" lower then the rear is this ok or is it to high and i will damage cv joints when in 4wd:nenau. by the way rear is standard height :thumbs

 

[makeitfit]

No worries mate, if the back end is std then a 1/2" drop at the front is not going to harm the CVs etc.:thumb2

 

[geoffdown]

No worries mate, if the back end is std then a 1/2" drop at the front is not going to harm the CVs etc.:thumb2

thanks just what i wanted to hear:thumbs it glides over bumps now much smoother

 

[lacroupade]

Yes that wishbone measurement is far too difficult to do accurately...far easier to just do it rough and ready by having the front 1-2 cms lower than the back.

But keep an eye on it as it takes a few days to settle and might need tweaking.