ok so how

[zippy656]

hi, so how do i get the trim off thats over the the seat belt for the driver on a LWB. I want to run the CB cable up behind there so its not just dangling.

got the CB fited in the cubby hole. pics and text will follow later..

 

[jims-terrano]

I've never done it but be carefull it don't fowl the seatbelt.

Jim T

 

[zippy656]

yep, was going to tape it into place too..

 

[rossco]

You should be able to pull off your rubber seals around the door frame as the seals hold the covers on and then the covers should come off with a gentle pull up to slide it out.

 

[extreme-4x4]

pete done it recently the top of the seatbelt that is at the highest point. you have to remove the top/ front section of that. to reveal a screw, to remove it

then the pillar cover just clips off

if your stuck call me ill text you petes number if i cant explain it better

but cant you just tuck it in

 

[makeitfit]

Hey Zipps there's loads of room INSIDE the door seal if you want
If you want the cover off just carefully prize off the plastic cover of the sliding up and down bit for the seat belt. Then undoo the bolt and pull off the cover
Simples:thumb2

 

[zippy656]

will give it a go when it stops raining again