Negative camber on o/s wheel after lift

[niks_terrano ii]

Guys I seem to have negative camber on my o/s wheel after lifting my truck and it's dragging the steering around

I've replaced upper and lower ball joints track rods and also have makeitfits steering mod which is the bollox !

But when I tried to have the truck tracked after all the suspension had been changed the guy said to me the off side wheel has a lot of negative camber and can't track the truck properly also the truck pulls left badly !

Not too mention the steering wheel is no longer straight.

The steering wheel when the truck seems to go straight is at 10 to 4 rather than 9 to 3 if that makes sense.

What's the best way to alter the camber ?

I've seen these spacers on eBay for the upper ball joint and I've also seen that I can add shims ?

What do you guys think is best to do ?

The truck is all over the road at the mo nasty to drive !

 

[makeitfit]

You must do the top arm shims to correct camber. It's straight forward just use the online manual or else it's trial and error.
In the mean time you can do a basic tracking with some string pulled tight across the back and front wheels at mid point , like quarter to 3 , adjust wheels so the string touches all four points of the tyres